top of page
Jeep Wrangler & Gladiator Installation
Parts - Strap, Neoprene Strips
1. INSTALL STRAPS - Run straps through the channel starting at the top with the flat side facing the step.
2. Allow 4" to 5" of strap to extend out of the step.
3. Place step in chosen location paying careful attention not to scratch or damage the paint or body. (use a sheet of paper against the body during install for additional protection)
4. Push / Snap step into place and move the top straps to an open location (around connections).
5. Connect strap and pull tight until flush with the bottom rear part of the rail.
6. REMOVAL - Release the strap's quick disconnect and do everything in reverse.
OPTIONAL - If you'd like a tighter fit, adhere the neoprene strips to the INSIDE TOP of the hook.
Questions, Concerns, Feedback?
Need Shims?
Just email me
info@elayerprint.com
bottom of page