Snap-On Side Steps for Jeep Wrangler / Gladiator rock sliders
Tool-Free Install in Seconds!
 
RockLoks steps snap directly into your factory rock sliders—no tools, no bolts, no hassle. Install in seconds, remove just as fast for off-road clearance. Although easy to remove, they lock in place with included straps for a secure, sturdy fit.
 
Made from carbon fiber-reinforced PETG, they’re lightweight, strong, and built for the elements.
 
Choose your style:
    •    Bigfoot (5”) – Balanced for daily use
    •    Titan (7”) – Wide & stable
    •    Goliath (9”) – Maximum coverage
 
Sold in sets of 1, 2, or 4 — line them up, space them out, or go full coverage.
Small but mighty. Snap in. Step up. Hit the trail.
 
SPECIAL ATTENTION: The gap between your original rock rail and the body of your Jeep can vary. In rare cases, the gap may not be large enough to accommodate the step. It is your sole responsibility to verify that the steps will fit. You will also be fully accountable for any damage to the body, paint, or other components of your vehicle. The gap should be at least 10 millimeters (.39 inches) or roughly the width of five credit cards.
 
⸻
 
These steps are produced when ordered and may take a few days before they are shipped. In some cases inventory is able to be produced in advance for faster ship times, however this is rare. Thank you for your understanding and patience, Philip
 
⸻
 
 
Disclaimer
These 3d printed steps have been tested to hold over 600 pounds of downforce under controlled conditions. However, all 3d printed products are subject to variations in material strength, performance, and durability due to factors such as, but not limited to:
- Inherent inconsistencies in the 3d printing process
- Environmental exposure (e.g., temperature, UV radiation, moisture)
- User installation, handling, and wear over time
The customer assumes all risks and responsibilities associated with the use, installation, and handling of this product.
The manufacturer shall not be held liable for any damages, injuries, or losses arising from:
- Product failure due to inconsistent printing specifications or results
- Improper or insufficient installation
- Environmental conditions or wear and tear
- Misuse, negligence, or any other cause, foreseeable or unforeseeable
By purchasing and using these 3d printed steps, the customer acknowledges and accepts these terms in full, waiving any and all claims against the manufacturer for any reason whatsoever. Regular inspection of the product for signs of wear, damage, or improper attachment is strongly recommended before each use. These steps are intended for static use only and are not designed for high-impact or dynamic loads. Use of the product is done entirely at the customer’s own risk.
 
 
Limited Warranty Statement
The manufacturer offers a limited warranty on 3d printed steps for a period of 180 days from the date of purchase. This warranty covers defects in materials or workmanship that occur under normal use and proper installation as intended.
Exclusions:
This warranty does not cover:
- Damage caused by improper installation, misuse, or modification of the product
- Wear and tear, environmental exposure, or conditions outside the product’s intended use
- Variations in strength, durability, or appearance inherent to the 3-D printing process
Warranty Claims:
To make a warranty claim, please email info@elayerprint.com with photos and a description of the issue. If a valid claim is submitted within the warranty period, the manufacturer may, at its discretion, repair or replace the product or provide a refund of the purchase price.
Limitations of Liability:
The manufacturer’s liability under this warranty is limited to the repair, replacement, or refund of the product and does not cover any incidental or consequential damages.
By purchasing and using this product, the customer acknowledges and agrees to the terms of this limited warranty.